Sleepers, pads and mats
MT-F1637: Rubber Mat, 18 in × 48 in
What sits between the steel and the roof membrane. These carry the load and protect the roof.
| Product type | Rubber mat |
|---|---|
| Cable runs | — (accessory) |
| Holes | — |
| Mounting | Non-penetrating |
| Material | Rubber |
| Length | 48 in | 1219.2 mm |
| Width | 18 in | 457.2 mm |
| Height | 1 in | 25.4 mm |
| Included | Mat |
| Packaging quantity | 1 |
| Net weight | 16.314 lb | 7.4 kg |
| Wind rating | Not published. Contact your ANDREW representative. |
| Compliance | ISO 9001:2015; RoHS: compliant; China-RoHS: below max concentration; UK-RoHS: compliant; REACH-SVHC: compliant |
| Spec sheet revised | 2025-03-12 |
Check before you order
- Thickness conflict: the title says 1/2 in × 18 in × 48 in, but the dimension table says 1 in high.
Install notes for this part
- Sleepers and pads carry the tray load into the roof. Get the roof manufacturer's written OK for each pad material on your membrane. Rubber and PVC aren't compatible with every membrane.
- Don't set sleepers so they dam water or block drains, scuppers or crickets.
- Recheck sleeper heights against the published thickness. Two of these sheets disagree with themselves (see flags).
Used with
- MT-F1585: PVC Roof Sleeper, no holes, 8 ft
Other sleepers, pads and mats
Source: ANDREW spec sheet MT-F1637 (PDF), revised 2025-03-12 · manufacturer product page. Warranty: see warranty requirements.