Sleepers, pads and mats
MT-F1585: PVC Roof Sleeper, no holes, 8 ft
What sits between the steel and the roof membrane. These carry the load and protect the roof.
| Product type | Roof sleeper |
|---|---|
| Cable runs | — (accessory) |
| Holes | — |
| Mounting | Non-penetrating |
| Material | PVC |
| Length | 96 in | 2438.4 mm |
| Width | 4 in | 101.6 mm |
| Height | 4 in | 101.6 mm |
| Included | Sleeper |
| Packaging quantity | 1 |
| Net weight | 14.33 lb | 6.5 kg |
| Wind rating | Not published. Contact your ANDREW representative. |
| Compliance | ISO 9001:2015 |
| Spec sheet revised | 2025-03-12 |
Install notes for this part
- Sleepers and pads carry the tray load into the roof. Get the roof manufacturer's written OK for each pad material on your membrane. Rubber and PVC aren't compatible with every membrane.
- Don't set sleepers so they dam water or block drains, scuppers or crickets.
- Recheck sleeper heights against the published thickness. Two of these sheets disagree with themselves (see flags).
Used with
Other sleepers, pads and mats
Source: ANDREW spec sheet MT-F1585 (PDF), revised 2025-03-12 · manufacturer product page. Warranty: see warranty requirements.