Adjustable splices
MT-F1597: Adjustable Splice for Bridge Kit, 12 runs
Joins bridge-kit sections, and is also how the tray changes direction. Each splice is a flat 45° wedge plate. One section bolts through fixed holes on its straight edge, and the other bolts through curved slots, so it can swing from 0 to 45°. A 90° turn takes two splices with a section between them. Count one splice per joint, matched to the run count.
| Product type | Splice kit |
|---|---|
| Cable runs | 12 |
| Holes | — |
| Mounting | Rooftop bridge kits |
| Material | Galvanized steel |
| Length | 33 in | 838.2 mm |
| Width | 33 in | 838.2 mm |
| Height | 1 in | 25.4 mm |
| Included | Hardware, Splices |
| Packaging quantity | 1 |
| Net weight | 19.842 lb | 9 kg |
| Wind rating | Not published. Contact your ANDREW representative. |
| Compliance | ISO 9001:2015 |
| Spec sheet revised | 2025-03-12 |
Install notes for this part
- One splice per joint between bridge-kit sections of the same run size.
- "Adjustable": set the splice so the sections stay in line and the sleepers stay flat on the protection layer. Use the assembly drawing for hardware and torque.
Used with
- MT-F1595: Rooftop Coaxial Cable Bridge Kit, 12 runs, 12-gauge cover
Other adjustable splices
- MT-F1573-11: Adjustable Splice for Bridge Kit, 4 runs
- MT-F1574: Adjustable Splice for Bridge Kit, 8 runs
Source: ANDREW spec sheet MT-F1597 (PDF), revised 2025-03-12 · manufacturer product page. Warranty: see warranty requirements.