Step-over
RT-ST: Rooftop Cable Tray Step-Over
A walk-over platform so crews and roof traffic can cross a tray run without stepping on it.
| Product type | Step over |
|---|---|
| Cable runs | — (accessory) |
| Holes | — |
| Mounting | Non-penetrating |
| Material | Hot dip galvanized steel |
| Length | 70.5 in | 1790.7 mm |
| Width | 41.5 in | 1054.1 mm |
| Height | 13.2 in | 335.28 mm |
| Included | Hardware, Step over |
| Packaging quantity | 1 |
| Net weight | 146.387 lb | 66.4 kg |
| Wind rating | Not published. Contact your ANDREW representative. |
| Compliance | ISO 9001:2015; RoHS: compliant; China-RoHS: below max concentration; UK-RoHS: compliant |
| Spec sheet revised | 2025-03-12 |
Check before you order
- No live-load (foot traffic) rating is published. Get one in writing if the step-over is part of a required egress or service path.
Install notes for this part
- Put one wherever the tray crosses a service path, a roof-hatch route or an HVAC access lane, so nobody steps on the tray or cover.
- Set it on approved membrane protection. At 146 lb, lift it, don't drag it.
Source: ANDREW spec sheet RT-ST (PDF), revised 2025-03-12 · manufacturer product page. Warranty: see warranty requirements.