SnapStak cover kits
RT-CB4D: Rooftop Cover Kit for SnapStak Snap-in Hangers, 4 holes
Covered channel for runs carried in SnapStak snap-in hangers. It is taller than the bridge kits, at 11 in, and ships with hold-down clamps and three sleepers.
| Product type | Cover |
|---|---|
| Cable runs | 4 |
| Holes | 4 |
| Mounting | Non-penetrating |
| Material | Galvanized steel |
| Length | 96 in | 2438.4 mm |
| Width | 20 in | 508 mm |
| Height | 11 in | 279.4 mm |
| Included | Channel, Hardware, Hold-down clamps, Sleepers (3) |
| Packaging quantity | 1 |
| Net weight | 85.98 lb | 39 kg |
| Wind rating | Not published. Contact your ANDREW representative. |
| Compliance | ISO 9001:2015 |
| Spec sheet revised | 2025-03-12 |
| Hardware dead load | 10.7 lb/ft (net weight ÷ 8 ft, before cables) |
Check before you order
- A 2015 distributor sheet for this family listed a PVC roof sleeper (MT-F1599) as the included sleeper. The current sheet only says 'Sleepers (3)', so confirm the sleeper type and that it's compatible with your roof membrane.
Install notes for this part
- For runs carried in SnapStak snap-in hangers. The hangers aren't in this kit, so order them separately for your cable OD.
- Ships with hold-down clamps. Install every clamp the assembly drawing calls for, because a loose cover is the first thing to go in a wind event.
- No splice part is listed for the cover kits. Take joint details from the assembly drawing.
Other snapstak cover kits
- RT-CB8D: Rooftop Cover Kit for SnapStak Snap-in Hangers, 8 holes
- RT-CB12D: Rooftop Cover Kit for SnapStak Snap-in Hangers, 12 holes
Source: ANDREW spec sheet RT-CB4D (PDF), revised 2025-03-12 · manufacturer product page. Warranty: see warranty requirements.